🚀 BambuLight Firmware Installer
Flash your ESP32-C3 Super Mini directly from your browser
📋 Requirements
- Board: ESP32-C3 Super Mini
- Browser: Chrome, Edge, or Opera (WebSerial support required)
- USB Cable: Data-capable USB-C cable
- Drivers: CH340 or CP2102 drivers (usually auto-installed)
- You can download the drivere here: https://learn.sparkfun.com/tutorials/how-to-install-ch340-drivers/all
🔧 Before You Start
Make sure your ESP32-C3 Super Mini is connected to your computer via USB. The board should appear as a serial port in your system.
Install Firmware
Click the button below to install the firmware on your ESP32-C3 board:
📝 Installation Steps
1. Connect your ESP32-C3 Super Mini to your computer
2. Click "Connect & Install" button above
3. Select your ESP32-C3 port from the list
4. Click "Install" and wait for completion
5. Your board will do a soft restart automatically with the new firmware
6. You must do a board power cycle to ensure the PIR reset, and all works as expected
⚠️ Troubleshooting
- Port not found: Check USB cable and drivers
- Flash failed: Try holding BOOT button while connecting
- Permission denied: Close Arduino IDE or other serial programs
- Browser not supported: Use Chrome, Edge, or Opera